| Hardware specifications | ||
| Fixed Ports | 48* 1G/10 GE Base-X SFP+ ports 8*40G/100G QSFP ports |
|
| Consloe | 1 | |
| MGMT | 1 | |
| USB | 1 | |
| Port Switching capacity | 2.5Tbps | |
| Forwarding Rate | 1904Mpps | |
| Flash/RAM | 8G/2G | |
| Temperature | Operating temperature: (-10 - 50)°C Storage temperature: (-40 - 70)°C |
|
| Humidity | Operating humidity: (10% - 90%) RH, non-condensing Storage humidity: (5% - 90%) % RH, non-condensing |
|
| Dimensions(L*W*H) | 440(L)*356(W)*44(H)mm | |
| Power | AC:100～240VAC,50～60Hz | |
| Power consumption | <200W | |
| Weight | <10Kg | |
| Lightning protection | 6KV | |
| MAC address table | 128K | |
| LED Indicator | Power,System ,Link/Act | |
| Software specifications | ||
| Interface | Ethernet interface operating modes(full duplex, half duplex, and auto- negotiation) | |
| Ethernet interface operating rates | ||
| Jumbo Frame | ||
| port-xconnect | ||
| Flow-control | Flow-control tx/rx | |
| Storm-control | Port based storm-control | |
| Port-block | Port-block(know/unknown unicast; know/unknown multicast/broadcast) | |
| Port-isolate | L2/L3/All Port-isolate | |
| Uni-direction isolate | ||
| L2 Protocol Tunnel | L2 Protocol Tunnel(support CDP/CFM/DOT1X/LLDP/SLOW-PROTO/STP/VTP | |
| Forward mode | Store-and-forward | |
| Cut-through | ||
| VLAN Access mode | Access/Trunk | |
| Default VLAN | ||
| VLAN Classification | VLAN Classification(port based/mac based/IP based/protocol based) | |
| QinQ | Basic QinQ | |
| VLAN Mapping(1:1 VLAN Translation) | ||
| VLAN Statistics | VLAN Statistics | |
| Private VLAN | Private VLAN | |
| Voice VLAN | Voice VLAN | |
| Guest VLAN | Guest VLAN | |
| MAC Address Table | Automatic learning and aging of MAC addresses | |
| Hardware Learning | ||
| Static and dynamic MAC address entries | ||
| Blackhole MAC | ||
| MAC Flapping detect | MAC Flapping detect | |
| Port Bridge | Port Bridge | |
| Link aggregation | Static-LAG & LACP | |
| LAG load balance(SLB) | ||
| LAG load balance(DLB) | ||
| LAG load balance(RR) | ||
| LAG Self-healing | ||
| Link aggregation weighting | ||
| STP | Spanning-Tree Protocol | |
| RSTP | Rapid Spanning-Tree Protocol | |
| MSTP | Multi-instance Spanning-Tree Protocol | |
| ERPS | Single ERPS ring | |
| tangent ERPS rings | ||
| intersecting ERPS rings | ||
| compatible with RRPP | ||
| Loop back Detect | Loop back detection | |
| IGMP Snooping | IGMPv1/v2/v3 Snooping | |
| Fast leave | ||
| Static IGMP snooping group | ||
| ARP | Static and dynamic ARP entries | |
| Aging of ARP entries | ||
| Gratuitous ARP | ||
| ARP proxy | basic ARP-Proxy | |
| local ARP-Proxy | ||
| IPv4 Static Routes | IPv4 Static Routes | |
| Black hole Routes | ||
| co-work with IP SLA | ||
| VRF(Virtual Routing and Forwarding) | ||
| uRPF check | ||
| RIP | RIPv1/v2 | |
| Route policy | Route-map | |
| IPv4 prefix-list | ||
| ICMP | ICMP redirect | |
| ICMP unreachable | ||
| IGMP | IGMPv1/v2/v3 | |
| IGMP-Proxy | ||
| IGMP SSM Mapping | ||
| VRRP | VRRP | |
| Track for VRRP | ||
| Smart Link | multi-instance | |
| load balance | ||
| Multi-Link | ||
| Monitor-link | ||
| Traffic classification | Traffic classification based on COS/DSCP (simple classification) | |
| Traffic classification based on ACL ( complex classification) | ||
| Traffic classification based on inner header of the tunnel packets | ||
| Traffic behaviors | Queue scheduling | |
| Remark the priority fields(COS/DSCP) of the packet based on ACL | ||
| Remark the priority fields(COS/DSCP) of the packet based on Table Map | ||
| Flow redirection | ||
| Flow mirror | ||
| Traffic policing | Traffic policing based on direction(in/out) of Port | |
| Traffic policing based on direction(in/out) of VLAN | ||
| Traffic policing based on direction(in/out) of flow | ||
| Traffic policing based on direction(in/out) of aggregated flow | ||
| Traffic shaping | Queue based traffic shaping | |
| Port based traffic shaping | ||
| Congestion management | SP(Strict Priority)scheduling | |
| WDRR(Weighted Deficit Round Robin)scheduling | ||
| SP + WDRR mixed scheduling | ||
| Congestion avoidance | TD(Tail Drop) | |
| WRED(Weighted Random Early Detection) | ||
| Traffic statistics | Packet counts and bytes statistics based on traffic classification | |
| Packet counts and bytes statistics based on the color after traffic policing | ||
| Forwarded and discarded packet counts and bytes statistics | ||
| SSH | SSHv1/v2 | |
| RSA Key generation | ||
| RADIUS | RADIUS | |
| AAA | Authentication | |
| Authorization | ||
| Accounting | ||
| Dot1x | Port based dot1x | |
| MAC based dot1x | ||
| Guest VLAN | ||
| ACL | MAC/IP ACL | |
| Basic Mode ACL | ||
| Port-group ACL | ||
| VLAN-group ACL | ||
| ACL UDF | ||
| Global ACL | ||
| Time Range | ||
| ARP Inspection | ARP Inspection | |
| IP Source Guard | IP Source Guard | |
| Port Security | Limitation on MAC address learning on interface | |
| VLAN Security | Limitation on MAC address learning on VLAN | |
| CPU Traffic Limit | CPU Traffic Limit | |
| Prevent DDOS attack | Prevent DDOS attack (ICMP Flood/Smurf/Fraggle/LAND/SYN Flood) | |
| Login filter | Telnet/SSH ACL filtering | |
| Telnet/SSH IPv6 ACL filtering | ||
| Link-Flapping detection | Link-Flapping detection | |
| DHCP | DHCP Server | |
| DHCP Relay | ||
| DHCP Snooping | ||
| DHCP Client | ||
| DHCP Option82 | ||
| DHCP Option252 | ||
| RMON | RMON | |
| NTP | NTP(Network Time Protocol) | |
| DNS | Static DNS Client | |
| LLDP | LLDP | |
| Command Line Interface | Configurations through CLI (Command Line Interface) | |
| Help information | Banner configuration | |
| Help information in English | ||
| Terminal service | Vty Terminal service | |
| Console Terminal service | ||
| Management interface | In-band management interface and configuration | |
| Out-band management interface and configuration | ||
| User privilege management | privileged user proirity and privileged commands | |
| SNMP | Network management based on SNMPv1/v2c/v3 | |
| Public and private MIB | ||
| Public and private Trap | ||
| WEB | Configuration and management based on WEB UI | |
| Smart Config | Smart Config(Automatically configuration when system start) | |
| Restore | Restore factory default configuration | |
| File system | File system(support directory and file management) | |
| Upload and download | Upload and download files through FTP or TFTP | |
| Upload and download files through Xmodem | ||
| Log & alarm | CPU usage display and alarm | |
| Memory usage display and alarm | ||
| Device temperature, PSU, FAN, status display and alarm | ||
| User operation logs | ||
| Management of logs, alarms, and debugging information | ||
| system diagnostics | Detailed Diagnostic-information collection | |
| Reboot | Manual reboot | |
| Schedule Reboot | ||
| Reboot Information logging | ||
| network diagnostics | Ping | |
| IPv6 Ping | ||
| Trace route | ||
| mirror | Port mirror | |
| Flow mirror | ||
| Remote mirror | ||
| Multi-destination mirror(m:n) | ||
| CPU statistics | To CPU/From CPU packets statistics | |
| L2 Ping | layer2 network connectivity detection - L2Ping (MAC Ping/Trace) | |
| Loop back | port loop back | |
| hardware loop back(internal/external) | ||
| System time | Time configuration | |
| Time zone | ||
| Product Information | Detailed information |
| SAXH3756S | 48* 1G/10G Base-X SFP+ ports,8*100G QSFP ports; |
PRODUCT CENTER
SUPPORT
ABOUT US
FOLLOW US
