■  Provide -48V DC power for powered devices (PDs), such as IP Phones, WLAN APs, and Bluetooth APs.
■  Compatible with both IEEE802.3at(30W) and IEEE802.3af(15.4W), can supply power to PDs under these two standards.
■  Automatically detect and supply power to IEEE802.3at and IEEE 802.3af compliant powered devices(PDs).
■  Only supply power to IEEE 802.3af/at compliant PDs, no worry about damaging other private standard PoE devices or devices without PoE function.
■  Support port power supply prioritization, guarantee the continuous power supply of key nodes.
■  Up to 100m network cable transmitting distance, support flexible network expansion without power line deployment concerns. Users can freely fix their wireless APs, IP cameras or other end devices on the wall or ceiling.
■  Support short-circuit protection function, the switch will automatically start short-circuit function and cut off the power supply when there is high-current or other power failures, which can efficiently defend against device damage or network failures caused by line fault or wrong installation.
■  POE intelligent strategy: POE intelligent diagnosis, POE timing restart, Power supply schedule.
Support CLI Management ,SNMP Management, simple WEB management, easy to configure the functions of switches.

Product Information
Product Model	SGX3728P-V2
Hardware specifications
Fixed Ports	24*10/100/1000Base-T PoE ports (POE/POE+) 4* 1G/10 GE Base-X SFP+ ports
Consloe	1
Reset	1
Max Output Power(single port)	30W
Total Power Consumption	400W
PoE Pin-out	1/2(+),3/6(-)
Switching capacity	128Gbps
Forwarding Rate	96Mpps
Flash/RAM	32MB/256MB
Temperature	Operating temperature: (0 - 45)°C Storage temperature: (-40 - 70)°C
Humidity	Operating humidity: (10% - 90%) RH, non-condensing Storage humidity: (5% - 90%) % RH, non-condensing
Dimensions(L*W*H)	440(L)*208(W)*44.5(H)mm
Power	AC:100~240VAC,50~60Hz
Power consumption	400W output the whole device
Weight	<5.8Kg
Lightning protection	6KV
MAC address table	16K
LED Indicator	Power,System ,Link/Act,POE

Software specifications
Forwarding mode	Store-and-forward
MAC Address	Static configuration and dynamic MAC learning(16K) MAC browsing and removal Configurable aging time of the MAC address Limited number of learnable MAC addresses (*) Black-hole MAC list (*)
Jumbo frame	12K
Port Characteristics	Support outbound and inbound port speed limit Support outbound and inbound port speed limit IEEE 802.3x traffic control for Full-Duplex mode Back-pressure traffic control for Half-Duplex mode Storm suppression for unknown Unicast, multicast, multicast, broadcast type Storm suppression based on bandwidth regulation and storm filtering DDM (received optical power, transmitted optical power, operating temperature, supply voltage and laser bias current) (*)
Port Aggregation	Support port aggregation Support static aggregation Support dynamic aggregation(LACP) Support source MAC payload Support destination MAC payload Support based on source and destination MAC load Support load based on IP address Support load based on TCP/UDP port number (*) Support cross-device link aggregation (*)
VLAN	4K support VLAN Port-based VLAN MAC-based VLAN (*) Protocol-based VLAN (*) VLAN based on IP subnet (*) Voice VLAN (*) PVLAN (*) GVRP (*) SuperVLAN (*) 802.1ad(QinQ)fixed Flexible QinQ (*)
Layer 2 Ring Network Protocol	802.1d STP, 802.1w RSTP, 802.1s MSTP PVST (*) Port Fast, Uplink Fast, Backbone Fast BPDU Guard, BPDU Filter, Root Guard Standard ERPS ERPS single ring single instance ERPS single-ring multiple instances Support multi-ring ERPS (*) EAPS (*)
IP Routing(IPv4)	Inter vlan Multi IP Default route Policy routing Equal-cost routing (*) Black hole routing (*) Static routing RIP v1/v2 OSPF BGP Active/Standby switchover VRRP Preemption/BFD/Track OSPF multi-process MD5 encryption authentication Route COST setting Inter-area route filtering
IPv6	IPv6-Ping,IPv6-Tracert,IPv6-Telnet,IPv6-TFTP,IPv6-ICMP RIPng OSPFv3 BGP4+ for IPv6 (*) VRRPv3 (*) IPv4/v6 dual stack protocol (*) IPv6 PMTU (*) MLD snooping (*) DHCPv6 Snooping (*) IPv6 ACL (*) Manual tunnel (*) ISATAP tunnel (*) 6-to-4 tunnel (*)
Multicast	IGMP V1/2(Snooping) IGMP V3(Snooping) (*) IGMP Proxy Multicast VLAN(MVR) (*) PIM-DM/SM/SSM (*) MLD V1/2 (*)
DHCP	DHCP Server DHCP Client (*) DHCP Relay DHCP Snooping DHCP Snooping Option80/82/60/66 (*)
Mirror	Support port mirroring for incoming port packets Support port mirroring for outgoing port packets Support port mirroring for inbound and outbound packets Support mirroring of one pair of multiple destination ports (*) Support mirroring of many to multiple destination ports (*) Support multi-to-one destination port mirroring Support Stream mirroring (*) Support CPU mirroring
ACL/QoS	Access list based on source mac Mac access list based on ethertype Ip access list-standard ACL Whether to support the access list of the time period ACL verification of source IP address ACL verification of the destination IP address ACL verification of source port ACL verification of the destination port ACL verification of the specified protocol (*) Support 802.1P (CoS) priority marking Support DSCP priority re-marking Support 802.1P/DSCP priority mapping Support flow-based qos marking (*) Support Qos based on VLAN (*) Support Qos based on COS/DSCP Support any-based Qos (*) Support Qos based on mac/ip access list (*) Support modifying COS value/DSCP value (*) Support redirection (*) Support drop (*) Support speed limit (*) Support adding outer vlan (*) Support 8 queues Support for per-queue rate limiting (*) Support SP, WRR, SP+WRR and other scheduling modes Support congestion avoidance mechanisms such as Tail-Drop and WRED (*)
Safety Features	Support port-based 802.1X local authentication Support 802.1X remote authentication Support Guest VLAN (*) Support port-based MAC address filtering Authentication based on MAC address Support Portal authentication (*) Support Radius authentication TACACS+ (*) Loop detection (private) Anti-Secondary Loop (*) Support port isolation Single port isolation Multiple groups of port isolation IP Source Guard Port security ARP Aing/Bnding/Proxy Support dynamic ARP detection (*) Support anti-DDoS attack, TCP SYN Flood attack, UDP Flood attack, etc. (*) Support storm suppression for multicast/unknown unicast/broadcast
MPLS	MPLS VPN (*) MPLS TE (*)
Virtualization	Horizontal stack (*) Vertical stack (*)
Energy saving	IEEE 802.3az (*)
Management and Maintenance	CLI: Console, Telnet, SSHv1/2 Web-GUI: HTTP, HTTPS SNMPv1/v2 SNMP v3 (*) SNMP Alarm/Inform/Traps RMON Support RMON(Remote Monitoring)Alarms, Events, History (*) Support LLDP NTP v1/2 IEEE 1588v2 (*) System log (operation log, alarm log) Syslog support (*) Support user hierarchical management and password protection Support FTP/TFTP loading and upgrading Support restore to factory mode Debugging Support cloud box unified network management (TG unique) Support cloud management
POE	Support 802.11af/at Power Supply Power and data at the same time Power supply pin 1/2(+), 3/6(-) POE intelligent diagnosis POE timing restart Single port output maximum power 30W Power priority setting
Notes	(*) means this functions under the development plan

Product Information	Detailed information
SGX3728P-V2	24*10/100/1000 Base-T ports(POE/POE+),4* 1G/10 GE Base-X SFP+ ports,IEEE 802.3af/at,Total Output Power: 400W;
Transceivers
SFP+-10GE-SX-MM850	SFP+ Module(850nm,300m,LC)
SFP+-10GE-LX-SM1310	SFP+ Module(1310nm,10km,LC)
SFP-GE-SX-MM850	1000BASE-SX SFP Transceiver, Multi-Mode (850nm, 550m, LC)
SFP-GE-LX-SM1310	1000BASE-LX SFP Transceiver, Single Mode (1310nm, 20km, LC)
SFP-GE-SC-1310	SFP Gigabit optical module, TX1310/RX1550 (20km, SC)
SFP-GE-SC-1550	SFP Gigabit optical module, TX1550/RX1310 (20km, SC)