Product Information | |
Product Model | SFG2510P |
Hardware specifications | |
Fixed Ports | 6*10/100 Base-T ports(POE/POE+) 2*10/100/1000 Base-T ports(POE/POE+) 2* 1000 Base-X SFP ports |
Consloe | 1 |
Reset | 1 |
Max Output Power(single port) | 30W |
Total Power Consumption | 150W |
PoE Pin-out | 1/2(+),3/6(-) |
Switching capacity | 9.6Gbps |
Forwarding Rate | 6.85Mpps |
Flash/RAM | 16MB/128MB |
Temperature | Operating temperature: (-10 - 50)°C Storage temperature: (-40 - 70)°C |
Humidity | Operating humidity: (10% - 90%) RH, non-condensing Storage humidity: (5% - 90%) % RH, non-condensing |
Dimensions(L*W*H) | 280(L)*180(W)*44(H)mm |
Power | AC:100~240VAC,50~60Hz |
Power consumption | 150W output the whole device |
Weight | <2.5Kg |
Lightning protection | 6KV |
MAC address table | 8K |
LED Indicator | Power,System ,Link/Act,POE |
Software specifications | |
Forwarding mode | Store-and-forward |
Protocol and Standards | IEEE 802.3, 10 Base-T Ethernet; |
IEEE 802.3u,100 BASE-TX; | |
IEEE 802.3ab,1000 BASE-T; | |
IEEE 802.3z,1000 BASE-X; | |
IEEE 802.3az,EEE(Energy Efficient Ethernet); | |
IEEE 802.3af | |
IEEE 802.3at | |
MAC Address Table | Up to 8K MAC addresses |
Support auto-update, two-way learning | |
Buffer Memory | 4.1Mbit |
Jumbo Frame | 9K Bytes |
VLAN | Port-based VLANs |
4K-entry Vlan Table | |
VLANs based on IEEE 802.1q | |
Spanning Tree | Support Spanning Tree Protocol |
Support Rapid Spanning Tree Protocol | |
Link Aggregation | Support 8 aggregation groups, and a maximum of 8 ports in each aggregation group |
Static aggregation and LACP | |
Port Mirroring | Support bi-direction port mirroring |
RSPAN function for remote mirroring | |
Port Isolation | Isolation between downlink ports without influence the communication between downlink and uplink ports |
Port Flow Control | Back-pressure traffic control under Half-Duplex mode |
IEEE 802.3x traffic control under Full-Duplex mode | |
Port Rate Restriction | Port-based ingress or egress rate limiting |
DHCP | DHCP Snooping |
IPv6 | ICMP v6, Telnet v6 |
Storm Suppression | Support the suppression of broadcast storm based on forwarding rate |
Multicast Control | Support IGMPv1/2/3 and MLDv1/2 Snooping. |
Security | Attack Prevention(Land attack\Blat attck\Ping attack\TCP control flag attrck) |
MAC & Port based Security | |
QOS | 802.1p(Port Queuing Priority) |
WRR (Weighted Round Robin) | |
Cos/Tos,QOS | |
PoE | PoE ouput priority Management |
Intelligent restart | |
Timed restart | |
Physic Medium | 10/100Base-TX:UTP category 3/4/5 cables( Maximum 100m) |
1000Base-T:UTP Category 5 cable( Maximum 100m) | |
1000Base-SX:fiber with 850nm wavelength,supports a max transmission distance of 550m | |
1000Base-LX:fiber with 1310nm / 1550nm wavelength,supports a max transmission distance of 80km | |
Network Cable Deployment | Support Auto-MDIX function, automatically identify straight forward cable and cross-over cable |
Negotiation Pattern | Support port auto-negotiation function( automatically negotiate transmission rate and Duplex modes) |
Maintenance | Detect the connectivity of network cables |
Uploading or downloading of the configuration data | |
Uploading of upgrade patch | |
Support system logs | |
WEB-based reset to factory defaults | |
Management | WEB-based management |
CLI Management (Command Line Interface) | |
Telnet | |
SNMP |
Product Information | Detailed information |
SFG2510P | 6*10/100 Base-TX ports(POE/POE+), 2*10/100/1000 Base-T ports(POE/POE+), 2* 1000 Base-X SFP ports, IEEE 802.3af/at,Total Output Power:150W. |
Transceivers | |
SFP-GE-SX-MM850 | 1000BASE-SX SFP Transceiver, Multi-Mode (850nm, 550m, LC) |
SFP-GE-LX-SM1310 | 1000BASE-LX SFP Transceiver, Single Mode (1310nm, 20km, LC) |
SFP-GE-SC-1310 | SFP Gigabit optical module, TX1310/RX1550 (20km, SC) |
SFP-GE-SC-1550 | SFP Gigabit optical module, TX1550/RX1310 (20km, SC) |